bondtech heatlink 300 c thermistor gehärtet Wassen en uitharden: Gecombineerd in

Wassen en uitharden: Gecombineerd in één apparaat

With a consistent diameter and a low diameter tolerance of +/- 0

Sorgfältiger Herstellungsprozess

Automatisch je nach Durchmesser des Objekts

bondtech heatlink 300 c thermistor gehärtet Wassen en uitharden: Gecombineerd inBondtech HeatLink 300C Thermistor Customize it to your liking! The Bondtech HeatLink 300C Thermistor is based on the SeMitec 104NT 4 R025H42G temperature sensor and uses a Molex Micro Fit 3. 0 female connector. This allows easy expansion with one of the HeatLink interface cables to connect it effortlessly to your 3D printer. To customize your Marlin2. 0 for this thermistor, use the following code: #define TEMP_SENSOR_0 5 Check the R T table here: